Basic Functions; Switching On The System - Nolan n-com bluetoothkit Seguridad E Instrucciones

NOLAN nCOM bluetooth 0024
- After positioning the Basic Kit inside the helmet, apply the adhesive sealing trim around the 10-way connector as follows:
• Remove the N-Com protection cover from the helmet (fig. 2).
• Remove the protective film from the gasket.
• Apply the sealing trim around the 10-way connector as shown in figure 3 and 4.
- Insert the e-box in its compartment (fig. 5). First insert the front part, then press down on the e-box until both fasteners
click (fig. 6). To remove the e-box, operate at the same time on both sliding hooks until the e-box is ejected (fig. 7).
Warning: Do not leave the helmet exposed to atmospheric agents without the e-box or the protection cover supplied with
the helmet.
FIG. 2
FIG. 5

4. BASIC FUNCTIONS

All functions available on the N-Com system can be turned on using 3 keys: " ", "on" and "
command is confirmed by a special acoustic signal, depending on the requested function. This means that you can use all
the functions while wearing your helmet.

4.1 Switching on the system

- Insert the Intercom e-box in the relevant housing on the helmet.
- Press the "on" key and keep it pressed for 2 seconds until the LEDs turn on and you hear a buzz in the earphone.
23-05-2006 16:15
FIG. 3
FIG. 6
23
Pagina 23
FIG. 4
FIG. 7
L L M M
ENGLISH
" located on the e-box. Each