Bolting Down Your Safe; Bolt Down Instructions - SentrySafe SFW123BDC Manual Del Propietário

Bolt down instructions

WARNING: DO NOT drill through bolt cups.
WARNING: DO NOT bolt through the walls.
WARNING: Do NOT drill from any location inside the safe.
Bolt down kit contents (in select models only):
• 2 lag screws.
• 2 washers.
• 2 masonry anchors.
Tools needed to bolt safe to the floor:
• Drill.
• Wrench.
• ⁄ " (11 mm) drill bit – for drilling into the safe.
7
16
• 9 ⁄ " (7.2 mm) drill bit – for drilling into a wood floor.
32
• ⁄ " (9.5 mm) drill bit – for drilling into a masonry floor.
3
8
1
Close the door. Tip the safe onto its left side (door hinges horizontal with the floor).
2
3
Tip the safe upright, place the safe in the desired location and open the door.
4

Bolting Down Your Safe

Look to the bottom of the safe for two indentations on the feet
in opposite corners. Using the
through each indentation perpendicular to the bottom of
the safe. Do NOT drill from any location inside the safe.
Use a screw or pencil to mark the floor through both holes.
10
⁄ " (11 mm) bit; drill a hole
7
16