Programming Your Fingerprint - SentrySafe SFW123BDC Manual Del Propietário

Programming your fingerprint

(2 fingerprints allowed per person using the safe)
To ADD a user fingerprint:
Press the "PROG" key twice.
1
Enter the 5 digit factory code.
2
The blue light will blink when the system is waiting for a finger swipe.
3
Swipe your finger in the downward direction over the fingertip sensor.
NOTE: If your finger swipe was accepted, a green light will flash and a beep will sound. If your
finger swipe was not accepted, a red light will flash and a low beep tone will sound.
Five to ten accurate reads of the fingerprint are necessary for successful enrollment.
4
Successful enrollment occurs when the green light flashes three times and three
beeps are heard. Once this happens, you can swipe a second finger if you wish to
enroll two fingerprints.
If enrollment is unsuccessful, the red light will flash three times and three low beep
5
tones are heard. The system will then shut down and you should repeat steps 1-4.
To DELETE a user fingerprint:
Press the "PROG" key twice.
1
Enter the 5 digit factory code.
2
Press the "CLEAR" button.
3
NOTE: The biometric lock asks for two fingerprints when programming a user fingerprint. If you
would like to only use one, allow for lock to timeout or press the "CLEAR" button.
NOTE: You are allowed 10 errors when enrolling a fingerprint – if you cannot enroll a finger in
that time, the system will flash a red light three times, beep three times, and shut down.
Try enrolling again by repeating steps 1-4.
Unlocking your safe using a fingerprint
NOTE: Make sure the handle is in the horizontal position before entering your code or unlocking
with your fingerprint.
NOTE: Key lock must be in the unlocked position, signified by the lock cylinder being popped out.
1
Programming a Fingerprint
Press the "CLEAR" button to first awaken your safe.
6
P
(