Balanced Body Clinical Reformer Manual De Instrucciones página 7

ATTACH THE SPRINGS TO THE UNDERSIDE
OF THE CARRIAGE
1. Locate the bracket with five eyebolts attached beneath the
carriage. Hook the springs onto the eyebolts. The hook should
be facing down.
2. The bodies of the springs
should rest on the flat,
padded brace under the
carriage (Figure F).
INSTALL THE SPRINGBAR
3. If your Reformer is configured with a no-roll springbar, install
it into the "gears" under the footbar with its hooks facing up.
INSTALL THE RISERS
4. Remove the detent pin from the metal riser receiver and insert
the riser with the pulley facing the carriage. Re-insert the
detent pin to set the desired riser height.
ATTACH THE ROPES
5. To attach the ropes, first
engage at least one spring
from the carriage to the
springbar to stabilize the
carriage. Unroll the ropes and
separate them.
6. Clip a cotton loop onto the
end of each rope and hang the
loops on the shoulder rests. (Figure G.) Thread the other end
of each rope through a pulley and back into the cam cleats
on the carriage to adjust the length. Be sure to go through
the chrome eyestraps on both sides of the cam cleats. Always
push the rope firmly down into the cleats to ensure a good
drip.
USING THE EXTENSION STOPPER
To limit the carriage travel, insert the extension stopper into the
desired hole in the top of the frame rail.
If you have any questions, please call Balanced Body at
1-800-PILATES (1-800-745-2837) or +1-916-388-2838.
Figure F
Figure G
EASY TO USE PLUNGER LOCKOUT KNOBS
Balanced Body's Allegro Reformer, and Clinical Reformer
®
Studio Reformer with Infinity footbars come with plunger lockout
®
knobs that make adjusting and moving the Reformer footbar
along the frame much easier.
To use, pull the plunger knob straight out so that the recessed
cross-pin comes out of the slots as shown in Figure H. Then turn
the knob so that the cross-pin rests on the bolt head as shown in
Figure I. Repeat on other side.
With the knobs in the "locked out" position, reposition the
footbar along the frame of your Reformer as desired. Then turn
the knobs so that the cross-pin is once again recessed, firmly
locking the footbar into its new position.
Figure H
Figure I
INSTALLING THE JUMPBOARD ON A CLINICAL
REFORMER WITH AN INFINITY FOOTBAR®
To install the jumpboard
(regular or Jumpus Maximus)
on a Reformer with an Infinity
Footbar, first loosen the two
black plastic knobs beneath the
standing platform at the foot
end of the frame.
Adjust the footbar to the 4th
position from the end of the
Reformer. Then adjust the footbar to the second highest vertical
position (Figure J). Next, place the tongue of the jumpboard into
the silver bracket on the inside of the frame. Finally, re-tighten
the black knobs on the outside of the frame.
and
®
Figure J
6