Display Indications - Alliance Laundry Systems HC18SN2 Operación Y Mantenimiento

Operation

Display Indications

Table 1 through Table 4 list the various displays and
what they mean. The operator should become familiar
with these computer displays.
Display
S-05 Program identification code (ROM)
(this is an example only)
HoLd Wait...power has just been turned on
CY Cycle (followed by two-digit number)
CHEC/CYC* Test cycle selected
FAr Degrees Fahrenheit
CEL Degrees Celsius
PrE Prewash segment (1st of 8 segments)
UASH Wash segment (2nd of 8 segments)
FIL1 First rinse (3rd of 8 segments)
FIL2 Second rinse (4th of 8 segments)
FIL3 Third rinse (5th of 8 segments)
FIL4 Fourth rinse (6th of 8 segments)
FIL5 Fifth rinse (7th of 8 segments)
FIL6 Sixth rinse (8th of 8 segments)
CFIL Cold fill
n
SPIn/tI E* Reads "SPIn" for one second, then
n
"tI E" followed by time for spin
tSFL Temperature sensor failure or
temperature out of range
*Display indications separated by a slash (/) represent an alternating display.
8
Display Indications for S-Series – Non-Coin
Meaning
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display
bFIL Warm fill (both hot and cold)
HFIL Hot fill
LOLE Low water level
HILE High water level
SUP1 Supply 1
SUP2 Supply 2
SUP3 Supply 3
SUP4 Supply 4
SUP5 Supply 5 (supply 1 and 2)
SUP6 Supply 6 (supply 2 and 3)
SUP7 Supply 7 (supply 3 and 4)
STOP Stop routine
SdLY Spin coast delay
donE Cycle and stop routine have ended
door Door not properly closed
FILL/STOP* Programmed water level not reached
after 30 minutes
FULL The computer detects low water level or
higher when none should be present
Table 1
Meaning
F232137