Installation; Mounting - Resol HKM3 Manual De Instrucciones

2

Installation

2.1

Mounting

WARNING! Electric shock!
Upon opening the housing, live parts are exposed!
Î Always disconnect the device from power supply
before opening the housing!
Note:
Strong electromagnetic fields can impair the function of the controller.
Î Make sure the controller as well as the system are not exposed to
strong electromagnetic fields.
The unit must only be located in dry interior rooms. It is not suitable for installa-
tion in hazardous locations and should be protected against electromagnetic fields.
The device must additionally be supplied from a double pole switch with contact
gap of at least 3 mm.
Please pay attention to separate routing of sensor cables and mains cables.
Î Unscrew the crosshead screw from the cover and remove the cover.
Î Mark the upper fastening point on the wall. Drill and fasten the enclosed wall
plug and screw leaving the head protruding.
Î Hang the housing from the upper fastening point and mark the lower fastening
points (centres 180 mm).
Î Drill and insert the lower wall plug.
Î Fasten the housing to the wall with the lower fastening screws and tighten.
Î Complete wiring connections in accordance with terminal allocations, see chap.
2.2.
Î Place the cover back onto the housing.
Î Fasten the cover by means of the cross-head screw.
1
0 Auto I
0 Auto I 0 Auto I
3
o I o I u t u t A A 0 0
180mm
5
o I o I u t u t A A 0 0
Electrical connection see chap, 2.2
2
4
6
0 Auto I
0 Auto I 0 Auto I
17