Installation Instructions; Freestanding Outdoor Grill Installation - JENN-AIR 720-0727 Instrucciones De Instalación Y Manual De Uso Y Cuidado

INST ALLATION
INSTRUCTIONS

Freestanding Outdoor Grill Installation

WARNING
Excessive Weight Hazard
Use two or more people to move and install grill.
Failure to do so can result in back or other injury.
Unpack Grill
1. Remove all packaging materials and remove grill from the
shipping base.
2. Move grill close to desired outdoor location.
3. Open the grill hood.
Remove Packaging Material Inside the Grill
1. Use a utility knife to cut yellow straps and packing tape to
open box from top and remove the boxes.
2. Remove the warming shelf and grill grates from inside
the grill and remove the package inside the firebox.
3. Remove foam block and wrap from inside the grill.
4. Replace the grill grates.
5. Place warming shelf on brackets as shown.
A
A. Warming shelf bracket s
B. Warming shelf
12
B
A
Attach Side Shelf Push Bars and Baskets
1. Unpack the push bars, baskets, and tray
NOTE: The larger side shelf push bar and basket and the tray
install on the left side of the grill. The smaller side shelf push
bar and basket install on the right side of the grill.
2. Remove the four ¼" x 12 mm screws and four ¼" lock washers
from the grill side panel. See the illustration in Step 3.
3. Attach the right side shelf push bar by aligning the screw
holes in the grill with the screw holes in the push bar. Insert
the 4 screws and lock washers removed in Step 2 into the push
bar screw holes and then into the grill and tighten. Push in the
push bar brackets on each side to cover the screws.
4. Remove the four 5/32" x 10 mm Phillips head screws and four 5/32"
lock washers from the grill side panel. See the illustration in Step 5.
5. Attach side shelf push bar support to the grill by aligning the
screw holes in the grill with the screw holes in the support. Insert
2 screws and lock washers removed in Step 4 into the support
screw holes and then into the grill and tighten.
6. Attach the side shelf push bar support to the push bar with
a screw and washer from the underside of the push bar
.