JENN-AIR 720-0727 Instrucciones De Instalación Y Manual De Uso Y Cuidado página 17

3. Connect the quick connector on the other end of the
10 ft (3.0 m) PVC flexible gas supply hose to the rigid Natural
gas supply pipe.
A
B
A. Manifold
B. Left side panel
C. Natural gas pressure regulator/hose assembly
D. 10 ft. (3.0 m) PVC gas hose
Change Grill Burner Valve Orifices
1. Remove the grates and flame tamers.
2. Remove the screw and the clip that hold the burner in place.
Set the screwand clip aside. Remove the burner from the
grill by lifting the burner out.
B
D
C
A
A. Clip
B. Screw
3. Use a 6 mm socket and wrench or 6 mm nut driver to remove the
brass orifice from the end of gas valve. The main burner orifice is
located behind the LP orifice, so no additional orifice needs to be
installed.
Main Orifice M i O ifi
IMPORTANT: Check that the orifice is properly installed inside of
the burner opening.
4. Reinsert the burner and reattach using the screw and the clip
previously removed. Repeat the procedure for each main burner.
5. Positionthe igniters so they are ¼" (6.0 mm) away from each burner.
Change the Rotisserie/Infrared Burner Orifice
1. Using a Phillips screwdriver, unscrew the 2 screws and remove the
rotisserie/infrared burner wind baffle.
A. Wind baffle
LP Orifice LP O ifi
A
17