Palm m100 Serie Manual De Instrucciones página 23

Tap Local above the HotSync icon and select Cradle/Cable from
3.
the pick list below the HotSync icon.
Tap the HotSync icon to perform a HotSync operation.
4.
If your problem persists, check your computer settings.
Check your Windows computer settings:
Right-click the My Computer icon on your Desktop and choose
1.
Properties.
Click the Hardware tab, and then click Device Manager.
2.
Click the plus sign (+) next to Ports.
3.
If the port you are using for the HotSync cradle/cable shows an
exclamation point, you have a hardware conflict. To resolve this,
consult the documentation that came with your computer.
Click the HotSync icon
4.
Click the Local tab and make sure the Serial port setting matches
5.
the port where you connected the HotSync cradle/cable.
From the Speed list, choose the 9600 setting.
6.
Click OK and perform a HotSync operation. If you are still
7.
experiencing problems, complete steps 8 and 9.
Click the HotSync icon on the taskbar and choose Exit.
8.
Restart HotSync Manager by selecting Start, Programs,
9.
Palm Desktop, and then HotSync Manager.
If you get a warning that the port is in use, then either move your
NOTE
HotSync cradle/cable to a different COM (serial) port or disable the
conflicting device to perform HotSync operations.
Check your Mac computer settings:
Double-click the HotSync Manager in the Palm folder.
1.
Click the Serial Port Settings tab.
2.
Make sure Local is selected and that the port selection matches the
3.
port where your HotSync cradle/cable is attached.
If you get a warning that the port is in use, then either move your
NOTE
HotSync cradle/cable to a different port or disable the conflicting device
to perform HotSync operations.
on the taskbar and choose Setup.
Troubleshooting
23