5) Press the throttle control lever right down (fig. 15).
6) Hold the levers (fig.15) down and push the throttle
lock button (fig.16) right down.
7) Hold the button down and release the throttle
control lever.
This should lock the throttle lock button, so both hands
are free to operate the device.
8) Pull the starter grip (fig.17) completely as many
as 3 times.
9) Push the carburettor choke lever (fig.18) down
.
10) Pull the start cord (fig.17) until the engine starts up.
CAUTION - DANGER !! The engine starts
at half acceleration and as a result the line
head is spinning.
Let the engine run a few seconds.
11) Press the throttle control lever briefly (fig. 19
item1) and the throttle lock button will disengage
automatically. The engine will thus return to idle and
the line head will stop after a short while.
STOP ENGINE
1) To stop the engine, shut the power switch (fig. 19
item 2) "OFF".
CAUTION! The line head continues to spin
for a while even after the power switch has
been shut OFF. Hold both handles firmly until the
line head comes to a complete stop.
WARM ENGINE STARTUP
Proceed as with a cold engine startup but with the
choke lever down
GRASS TRIMMER OPERATING MANUAL
(see fig.18).
ON
Fig.10
OFF
Fig.12
Fig.14
1
Fig.16
Fig.18
GB
Fig.11
Fig.13
Fig.15
Fig.17
Fig.19
2
ON
OFF
1
13/
012