Using The Timer; Sleep Timer; Remote Control Unit (Rc-829) - Denon DRA-F100 Instrucciones De Operación

ENGLISH
8

USING THE TIMER

The time and timer functions are incorporated in the receiver.
Timer Settings
Types of timer operations
2
TIMER : Use this to turn the power on and off at the same times every day.
SLEEP TIMER : Use this to set the power to turn off after 10 to 60 minutes, in steps of 10 minutes (operated from the
remote control unit).
Notes on timer settings
2
• Be sure to set the current time beforehand.
• To listen to or record a radio program ("air check") using the timer, be sure to preset the station beforehand. (Refer to
"Presetting AM and FM Stations" on page 11.)
Power Failures
Should there be a power failure or should the power cord be unplugged, the time display will flash at "
happens, reset the current time.
Also check the timer and tuner presettings, and reset them if they have been cleared.
Checking the Settings
To check the timer settings, press the TIMER button for at least 3 seconds. (This can also be done when the tuner's
power is off.)
Next, press the MEMORY button repeatedly to display the timer start mode, the reception band and preset channel
number when in the tuner mode, the on time and the off time. Press the MEMORY button once more to return to the
current mode display.
Changing the Settings
Repeat the timer setting operation to erase the previous settings and set the new settings.
Clearing the Settings
Press the TIMER button for at least 3 seconds, then press it for at least 3 seconds again while "FUNC" is displayed to
clear the timer settings.
Note on Setting the Timer
If the time set with the timer is reached while the system power is on, the operation switches to the operation set by the
timer.
Turning the Timer Off
Press the TIMER button to turn the mark off.
12
The Time is displayed in the 12-hour mode
Receiver (DRA-F100)
B
REMOTE SENSOR
SYSTEM
ON / STANDBY
DOWN
PHONES
TIMER
2,4
". If this
Example: Setting to 7:30 p.m.
Press the DISPLAY button for at
1
least 3 seconds.
Use the TUNING UP and DOWN
2
buttons to set the hours.
3
Press the MEMORY button.
Use the TUNING UP and DOWN
4
buttons to set the minutes.
Press the MEMORY button at the
sound of a time service's chime.
5
The time display stops flashing and
the clock starts running.
• The current time can be set even when the power is off.
Setting the Current Time
PERSONAL COMPONENT SYSTEM / AM-FM STEREO RECEIVER DRA-F100
VOLUME
MHz CH
TIMER
TUNED STEREO AUTO
TUNING MONO / BASS TREBLE BALANCE
UP BAND STEREO
DISPLAY MEMORY FUNCTION
L R
1 3,5
DISPLAY
The hours place flashes.
(If the hours have already been set, that number flashes.)
TUNING
DOWN UP
The hours place flashes.
The minutes place flashes.
MEMORY
(If the minutes have already been set, that number
flashes.)
TUNING
DOWN UP
The minutes place flashes.
MEMORY
The display stops flashing and
the clock starts running from
00 seconds.