G Eneral Safety Informations; Se Of The Machine For Purposes For Which It Is Intended; I Ncorrect Use; D Eclaration Of Incorporation - SUHNER SHS 500 Documentación Técnica

1. n
1.1 g
enerAl sAfety infOrmAtiOns
This operation manual is applicable for the hand piece
SHS 500. The hand piece may only be handled by per-
sonnel who are qualified. Suitable safety and hygiene
measures must be taken.
It is imperative that you observe the safety instruc-
tions provided separately.
The working environment must be kept clean and
well illuminated. Keep away persons in the vicinity when
you are using the hand piece. Wear tight fitting clothing
and secure long hair.
V
ery shArp BlAde
Use only food grade (FDA approved) lubricants,
e.g. TURBO LUBE GREASE (Art.-Nr. 60000078),
TURBO LUBE SPRAY (Art.-Nr. 60000077). Do not
place the hand piece on a hard surface, but only in the
provided receiver.
1.2 u
se Of the mAchine fOr purpOses fOr
which it is intended
These hand piece is designed to process rough cut meat
on an industrial scale. It can be used to remove fat, tissue,
bones, and other small parts and to detach meat from
other animal parts.
1.3 i
ncOrrect use
All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.
1.4 d
eclArAtiOn Of incOrpOrAtiOn
The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
T. Fischer. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justi-
fied request. This partly completed machinery may be put
into operation only when the machine in which the partly
completed machinery is to be incorporated has been as-
certained to fulfil the conditions under the Machinery Di-
rective. CH-Lupfig, 10/2019. T. Fischer/Division manager
24
s
otes on aFety
!
2. c
2.1 A
ssemBly instructiOns
starting up the hand piece.
Use hand piece and shaft only when they are in perfect
working order.
Replace blades only when the hand piece has been de-
tached.
Always work with suitable protective equipment (chain-
mail glove / protective clothing). Observe the rules and
regulations applying in your country.
V
ery shArp BlAde
2.1.1 c
Onnecting the hAnd piece tO the flexiBle shAft
Introduce the flexible shaft into the hand pieces until it
snaps audible.
V
ery shArp BlAde
2.1.2 Detaching/connecting the depth gauge
Use an allen key to loosen the setscrews.
ommIssIonIng
It is imperative that
you read Sections
2 and 3 before
!
!