Notes On Safety - Vectron DURATEC POS S14 Avisos De Seguridad Y De Instalacion

D
a brand of Vectron
2 . Note s on s afet y
A DANGER
Deadly shock caused by damaged POS system components.
Ö Disconnect the mains cable from the power grid in case of damage.
Ö Contact your Vectron specialist retailer when POS system
components are damaged.
A CAUTION
Pinching of fingers when aligning the screen.
The gap between the screen housing and the joint changes during
alignment.
Ö Do not insert your fingers between the screen housing and the joint.
Ö Before aligning the screen see the notes in chapter 3.2 "Aligning the
screen" on page 26.
Danger of tripping and damaging device caused by device cables lying
unprotected in the room.
Ö Route the device cables so that they do not pose a potential hazard!
NOTICE
Damage of POS system components caused by excessively high voltages or
currents.
Ö Use an earthed socket to which alternating current between 110
and 240 volts is connected.
Ö Use power sources which are protected with a residual-current
circuit breaker.
Malfunctions caused by faulty programming.
Ö Only change the programming when your are absolutely sure of the
effects this will have.
Ö Protect the programming and programming functions with
passwords.
Ö Your Vectron dealer will support you should you have questions
on programming or will program the POS system according to your
requirements.
Damage of touch screen through unsuitable objects.
Ö Please touch the screen exclusively with fingers or the provided
stylus.
22
POS S14