Mounting Diagram - Lutron Homeworks seeTouch STWD-1B Manual Del Usuario

Installation
1.
Disconnect power to the keypads by turning OFF all
circuit breakers connected to the HomeWorks
Processor or keypad link auxiliary power supply
(HWI-PS).
Wiring with power ON may result in
personal injury.
2.
Remove currently installed button kit (if applicable).
Remove button kit from keypad by gently prying it
from the top. See Button Kit Removal.
3.
Address keypads. Assign a unique address to each
keypad using the DIP switch settings. See Keypad
Addressing for DIP switch location and switch set-
tings. Be sure to record the address for future pro-
gramming purposes. Replace Button Kit.
4.
Strip insulation to 3/8 in. (10mm).
5.
Unplug keypad link terminal block from the keypad
circuit board.
6.
Connect wiring to terminal block as shown in Wiring
Diagram (page 3). Each terminal will accept one or
two #18 AWG (1.0mm ) wires.
2
7.
Plug the keypad link terminal block back onto the
keypad circuit board. Be sure to orient the terminal
block correctly.
8.
Connect external input closures (if applicable). All
seeTouch keypads accept two low-voltage dry con-
TM
tact closures (see Wiring Diagram - page 3).
When using the input closures:
Verify compatibility of external devices. The input clo-
sures are intended for use with devices that provide
outputs in the form of dry contact closure outputs.
The input closures may be used with ground-refer-
enced, solid-state outputs if the outputs have an on-
Button Kit Removal
Using a small
flat blade
screwdriver,
gently pry
from top.
2
state saturation voltage of less than 2 VDC and an
off-state leakage of less than 50 µA. Dry contact or
solid-state outputs must be capable of switching
15 VDC at 10 mA. The outputs must stay in the
®
closed or open states for at least 40 msec in order to
be recognized by the keypad. If there is any question
as to whether the contact closure device is compati-
ble with these specifications, contact the manufactur-
er of that device.
9.
Push all wires back into the wallbox and loosely fas-
ten the control to the wallbox using the screws pro-
vided. Do not pinch the wires. See Mounting
Diagram.
10.
Attach Lutron
adapter and wallplate.
a. Loosely install keypad mounting screws.
b. Tighten wallplate adapter mounting screws
snug.
c. Tighten keypad mounting screws until
wallplate adapter is flush to wall (do not over-
tighten).
d. Snap wallplate onto wallplate adapter, and
verify button kit is not submerged.
e. If button kit is submerged, loosen mounting
screws appropriately.
11.
Restore power.

Mounting Diagram

Wallbox
Claro or Satin Colors
® ® TM
Keypad
Button
Mounting
Screws Kit
Keypad
Wallplate/Adapter purchased
separately.
wallplate
Adapter
Mounting
Screws