Safety Rules 1 - HAMPTON BAY Windward IV Manual Del Propietário

To reduce the risk of electric shock, insure electricity
1.
has been turned off at the circuit breaker or fuse box
before beginning.
All wiring must be in accordance with the National
2.
Electrical Code ANSI/NFPA 70-1999 and local electrical
codes. Electrical installation should be performed by a
qualified licensed electrician.
WARNING: To reduce the risk of fire or electric shock,
3.
this fan should only be used with fan speed control part no.
Fan28R-240W, manufactured by Chia Wei Electric Co., LTD.
WARNING: To reduce the risk of shock, this fan must be
4.
installed with an isolation wall control/switch.
CAUTION: To reduce the risk of personal injury, use only
5.
the screws provided with the outlet box.
The outlet box and support structure must be securely
6.
mounted and capable of reliably supporting a minimum of
35 pounds. Use only UL Listed outlet boxes marked "FOR
FAN SUPPORT."
The fan must be mounted with a minimum of 7 feet
7.
clearance from the trailing edge of the blades to the floor.
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK OR PERSONAL
INJURY, MOUNT TO OUTLET BOX MARKED "ACCEPTABLE FOR
FAN SUPPORT OF 35LBS (15.9KG) OR LESS" AND USE MOUNTING
SCREWS PROVIDED WITH THE OUTLET BOX. OUTLET BOXES COM-
MONLY USED FOR THE SUPPORT OF LIGHTING FIXTURES ARE NOT
ACCEPTABLE FOR FAN SUPPORT AND MAY NEED TO BE REPLACED.
CONSULT A QUALIFIED ELECTRICIAN IF IN DOUBT.
READ AND SAVE THESE INSTRUCTIONS
Do not wait for the fan to stop to press the reverse button.
8.
The fan will not reverse if the fan is not moving.
Avoid placing objects in path of the blades.
9.
To avoid personal injury or damage to the fan and
10.
other items, be cautious when working around or
cleaning the fan.
Do not use water or detergents when cleaning the fan or fan
11.
blades. A dry dust cloth or lightly dampened cloth will be
suitable for most cleaning.
After making electrical connections, spliced conductors
12.
should be turned upward and pushed carefully up into
outlet box. The wires should be spread apart with the
grounded conductor
conductor on one side of the outlet box.
Electrical diagrams are for reference only. Light kits that are
13.
not packed with the fan must be UL Listed and marked suit-
able for use with the model fan you are installing. Switches
must be UL General Use Switches. Refer to the instructions
packaged with the light kits and switches for proper assembly.
WARNING: To reduce the risk of fire or electric shock, do
14.
not use this fan with solid-state speed control device.
All set screws must be checked and retightened where nec-
15.
essary before installation.
TO REDUCE THE RISK OF PERSONAL INJURY, DO NOT BEND THE
BLADE BRACKETS (ALSO REFERRED TO AS "FLANGES") DURING
ASSEMBLY OR AFTER INSTALLATION. DO NOT INSERT OBJECTS IN
THE PATH OF THE BLADES.
and the equipment-grounding

Safety Rules 1.