Transmitter Operation; Operating Your Fan; Operating Your Remote Control - HAMPTON BAY Windward IV Manual Del Propietário

DO NOT WAIT FOR THE FAN TO STOP TO PRESS
THE REVERSE BUTTON. THE FAN WILL NOT RE-
VERSE IF THE FAN IS NOT MOVING.
Speed settings for warm or cool weather
depend on factors such as room size, ceil-
ing height, number of fans, and so on.
The fan shipped from the factory with the
reversing switch positioned to circulate air
downward. If airflow is desired in the op-
posite direction, turn your fan off and wait
for the blades to stop turning, then slide the
reversing switch (located at the top of the
motor housing, refer to figure 7 on page 5)
to opposite position, and turn fan on again.
The fan blades will turn in the opposite di-
rection and reverse airflow.
Warm weather - (Forward) A downward
air flow creates a cooling effect as shown
in Figure 18. This allows you to set your
air conditioner on a higher setting without
affecting your comfort.
Cool weather - (Reverse) An upward air
flow moves warm air off the ceiling are as
shown in Figure 19. This allows you to set
your heating unit on a lower setting with-
out affecting your comfort.
10. Operating Your Fan and Remote Control
CAUTION - This device complies with part 15
of the FCC rules. Changes or modifications not
expressly approved by the manufacturer could
void your authority to operate this equipment.
Remote Control
Your fan is equipped with a remote control to
operate the speed and lights of your new ceiling
fan. For more information on how to install the
remote control, see the remote control instruc-
tion along with the remote control components.

Transmitter Operation

Figure 18
a. Load a fresh set of 4 "AAA" 1.5v batteries
(included) into the battery compartment.
b. FAN AUTO Button: Use this button to se-
lect Auto/Manual operation of your fan.
c. Fan speed "MANUAL"mode: Use the blue
button to adjust the speeds by pressing and
releasing the button each time to change
speeds from High to Low as follows;
OFF
HIGH
MEDIUM
LOW
d. Fan speed FAN AUTO mode adjusts the
speeds automatically based on the tem-
perature setting that you select. Follow
Figure 19
the steps below to set the temperature