HAMPTON BAY Windward IV Manual Del Propietário página 8

Collar
Ceiling
Canopy
WHEN USING THE STANDARD BALL/DOWN-
ROD MOUNTING, THE TAB IN THE RING AT
THE BOTTOM OF THE MOUNTING PLATE MUST
REST IN THE GROOVE OF THE HANGER BALL.
FAILURE TO PROPERLY SEAT THE TAB IN THE
GROOVE COULD CAUSE DAMAGE TO WIRING.
6.
Installing Fan to
the Outlet Box
Screw and
Lockwasher
(3 Screws)
WHEN MOUNTING THE FAN ON A SLOPED
Canopy
CEILING, THE STANDARD BALL/DOWNROD
Ring
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN.
1. Pass the 120-volt supply wires through the
Rubber
center hole in the ceiling mounting plate as
Gasket
shown in Figure 7.
Figure 11
2. Install the ceiling mounting plate on the
outlet box, by sliding the mounting plate
over the two screws provided with the outlet
box (Figure 7). When using close-to-ceiling
mounting, it is important that the mount-
ing plate be level. If necessary, use leveling
washers (not included) between the mount-
ing plate and the outlet box. Note that the
flat side of the mounting plate is toward the
outlet box (Figure 7).
3. Securely tighten the two mounting screws.
4. Carefully lift the assembly up to the ceil-
ing mounting plate. If using close-to-ceil-
ing mounting, hang the fan on the hook
provided by utilizing one of the holes at
the outer rim of the ceiling canopy (Fig-
ure 12). If using standard mounting, seat
the hanger ball in the mounting plate
socket. Make sure the tab on the mount-
ing plate socket is properly seated in
the groove in the hanger ball.
THE HOOK AS SHOWN IN FIGURE 12 IS ONLY
TO BALANCE FAN WHILE ATTACHING WIRING.
FAILURE TO HANG AS SHOWN IN FIGURE 12
MAY RESULT IN HOOK BREAKING, CAUSING
THE FAN TO FALL. HOOK MUST PASS FROM
INSIDE TO OUTSIDE OF CANOPY.
Figure 12