Kit Preparation; Kit Assembly - Metra 95-7345B Instrucciones De Instalación

KIT PREPARATION

1. Remove (3) screws and remove the vent
from the factory radio panel. (Figure A)
2. Using the supplied #8 x 3/8" Phillips
screws, install the vent to the kits trim
panel. (Figure B)
Continue to Kit Assembly
(Figure A)
(Figure B)

KIT ASSEMBLY

1. Secure the radio brackets to the radio
using the screws supplied with the
radio. (Figure A)
2. Locate the factory wiring harness and
antenna connector in the dash and
complete all necessary connections to
the radio. Metra recommends using
the proper mating adapter from Metra
and/or Axxess. Test the radio for proper
operation.
3. Secure the radio assembly to the dash
using the factory screws. (Figure B)
4. Snap the radio trim panel over the radio
assembly, then reassemble the dash in
reverse order of disassembly. (Figure C)
(Figure A)
(Figure B)
(Figure C)
REV. 5/15/2018 INST95-7345B
3