Dust Extraction Port; Speed Handle; Repositioning The Rear Vice Jaw - Evolution RAGE 4 Instrucciones Originales

www.evolutionpowertools.com
included on the vice jaw for ease and accuracy
of setting.
To angle the rear vice jaw:
• Loosen the lever handled locking screw
and the RH socket headed screw (Fig. 6)
• Turn the rear vice jaw to the required angle.
• Tighten the RH socket headed screw
securely using the supplied hex key.
• Tighten the lever handled locking screw.
Note: The lever handled locking screw has
a repositionable lever. Repositioning of the
lever may be necessary to ensure that the
locking screw can be tightened sufficiently
when the rear vice jaw is angled.
To reposition the lever:
• Remove the cross-headed screw that
secures the lever to the screw.
• Lift the lever off the hexagonal screw head.
• Reposition the lever as necessary and
replace the cross-headed screw.
Note: The swivelling front vice jaw will
automatically align with, and/or compensate
for, any angle to which the rear vice jaw
is set. The swivelling front vice jaw also
allows irregular shaped work-pieces to be
accommodated in the vice.
Note: A rubber vice jaw protector can be
attached to the swivelling front vice jaw.
This protector will help with the security of
the workpiece held in the vice and also help
prevent damage to the gripped workpiece.

DUST EXTRACTION PORT

WARNING: Dust can potentially be a danger
to the machines operator and to any nearby
colleagues.
We recommend that if you intend to use this
machine to cut material(s) that create dust
(timber, plywood, certain plastics etc.) that the
dust extraction port is fitted to the machine.
This will then allow a workshop dust extraction
system to be connected to the machine.
The operator should also wear a suitable dust
mask, and any other relevant PPE (Personal
Protective Equipment).
To fit the dust extraction port:
• Remove the four cross-headed screws and
their associated washers from the blanking
plate at the rear of the machine. (Fig. 7)
• Remove the blanking plate.
• Using the four removed screws fit the dust
extraction port in place of the blanking plate.
Note: When using a dust extraction system
with this machine follow the instructions
supplied with the dust extraction system
regarding safe operating procedures.

SPEED HANDLE

Note: One (1) of the arms of the tri-armed vice
tightening/loosening hand-wheel is drilled
and threaded.
Fit the 'Speed Handle' if desired to the vice
hand-wheel. The handle simply screws
into the threaded hole found in one of the
hand-wheel arms. (Fig. 8) Use a cross-headed
screwdriver to tighten the handle into its
service position.
REPOSITIONING THE
REAR VICE JAW
The rear vice jaw can be removed from the
machines base and repositioned. (Fig.9)
Note: There are two (2) possible positions
available because of the four (4) threaded
holes in the machines base.
To reposition:
• Remove the RH socket headed screw that
secures the rear vice jaw to the machines base.
• Remove the lever handled locking screw
and all washers that secure the rear vice
jaw to the machines base.
15