MICRODOS maxichlor Manual De Usuario página 4

B - INSTRUCTIONS
1 – Controller
 Choose an area which is easily accessible and close to the filtration controller. Install the
controller vertically, far enough away from the pool to respect the regulatory distance in force in
your own country. Do not cover it; let air circulate between the back of the box and the wall.
Any contact between the controller and the water from the pool may risk electrocution.
 Permanently connect the electronic box to the electric filtration box, controlled by the pump
contactor. Do not use an extension cord with a plug or use a plug to connect the unit. Turn off
the differential circuit breaker in advance. Ensure that the controller switches off when the
filtration pump stops
2 – Chlorination cell
 Place the electrolytic cell in a straight line, preferably horizontal; and after all other treatment,
cleaning or heating equipment. If necessary use the Ø 63/50 mm reductions.
Wait for all of the glue joints to dry before the pipes are put under pressure.
 Fit the cell waterproof seals using a little silicone grease. Tighten the 2 nuts by hand.
 Connect the cell supply cable to the controller. Remove the copper nuts and lock washers.
Position the terminals, lock washers then the nuts, in that order. The terminals can be positioned
on either pole. Tighten gently the smaller nut with a spanner to avoid a non-reversible leak in
the connections. Apply the 2 rubber protective covers.
3 – Optional : Grounding electrode kit
The Grounding electrode kit (réf. : KIT10MISTER0) removes static electricity from the water in the
pool, no matter where it has come from. In certain situations, static electricity can lead to abnormal
oxidation of the metallic parts which are in contact with the water in the pool. Link the electrode to
a peg in the ground (not supplied), complying with the regulation distances in force in your country.
IV. ACTIVATION
A – INTRODUCTION
When installing the device for the first time or at the beginning of a new season, it is imperative to check the
following points :
 The water temperature should be more than 15 °C.
 The pool water must be clear, free from algae or deposits.
 The water should be correctly balanced (ALK, TH):
 The pH of the water should be stabilised between 7,0 and 7,2.
4