Cooper Lighting MS245 Manual De Instrucciones página 8

LIGHTS STAY ON AT NIGHT
AND DO NOT TURN OFF
LIGHTS CONTINUOUSLY
BLINK ON AND OFF AT
NIGHT
LIGHTS ARE ON
DURING THE DAY
CANNOT ACTIVATE DUSK
TO DAWN MODE AT NIGHT
(OVERRIDE)
LIGHTS DO NOT COME ON
IN NIGHT TIME ON MODE
LIGHTS WILL NOT
RESPOND TO SELECTED
NIGHT TIME ON SETTING
Call for customer service and/or missing or damaged parts (800-334-6871)
Is there motion in the detection zone?
• Make sure the sensor is not picking up moving objects
such as trees, traffic, etc.
• If this is the case, reduce the sensitivity.
• Reposition motion sensor.
If there is no motion, then the unit may be in the override mode.
• Turn the light switch to the "OFF" position for 90 seconds,
and then back to the "ON" position. This will send the unit
back into the AUTO mode.
*If the lights continue to stay on, contact customer service.
Is the unit in the AUTO mode?
• Make sure the unit is not in one of the three Night Time
on modes.
The light given off from the unitʼs own lamp(s) is affecting the
motion sensor.
• Re-aim lamp(s).
• Reposition motion sensor.
Is the switch on the bottom of the motion sensor in the test
mode?
• Move the switch to the AUTO 4, AUTO 12, or Night Time
On position.
Is the motion detector shadowed?
• Reposition motion sensor.
Is the surrounding external ambient light too bright? (If so, the
unit may think itʼs daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
Are you allowing adequate time to enter the dusk to dawn
mode?
• Turn the light switch to the "OFF" position for 5 seconds,
and then back to the "ON" position.
Is there more than one fixture on an indoor wall switch?
• If so, put them on separate switches.
Is the sensor in the correct setting?
• Move slide switch to 2 hr, 4 hr, or 6 hr setting.
Was Night Time On setting changed after lights were already on
in a different Night Time On setting?
• Night Time On mode setting cannot be changed until
the next dawn once light is operating in that setting. See
"How to select your desired feature."
If lights do not come on at all in Night Time On mode:
Is the surrounding external ambient light too bright? (If so,
the unit may think itʼs daytime.)
• Re-aim the head.
• Relocate or reposition the unit away from the light.
8