Introduction To 24F.E.+2G.E. Gigabit Clustering Switch; General Description - Longshine LCS-SW2402S Manual Del Usuario

3. Introduction to 24F.E.+2G.E. Gigabit Clustering Switch

3.1 General Description

The device is a 24+2-port 10/100/Gigabit Ethernet clustering switch with
twenty-four 10/100Mbps RJ-45 ports and two Gigabit slide-in slots on the rear
panel for optional fiber/copper Gigabit modules.
Compare to the traditional 10/100Mbps Ethernet, the switch delivers a dedicated
10/100Mbps connection to every attached client with no congestion issue. The
gigabit ports also provide the fat pipe to the server or backbone connectivity for
boosting the total system performance. Moreover, the NWay auto-negotiation
operation automatically negotiates with the connected partners on the network
speed and duplex mode; that provides an easy way to integrate 10 / 100 /
1000Mbps networks with no pain. It is ideal for micro-segmenting large networks
into smaller, connected subnets for improved performance, enabling the
bandwidth demanding multimedia and imaging applications.
Out of the ordinary dumb switches, the 24F.E.+2G.E. Gigabit Clustering Switch
embedded advanced management capability; that the device can be remote
managed by Telnet, SNMP manager and Internet browser. This is much useful for
system manager to monitor and control the system efficiently.
Store-and-forward switching mode promises the low latency plus eliminates all
the network errors, including runt and CRC error packets. To work under
full-duplex mode, transmission and reception of the frames can occur
simultaneously without causing collisions as well as double the network
bandwidth.
The switch is plug-n-play without any software to configure and also fully
compliant with all kinds of network protocols. Moreover, the rich diagnostic
LEDs on the front-panel provide the operating status of individual port and
whole system.
E-8