Publicidad
Step 6
Step
Fasten the LEFT END (B2) to the LEFT MOLDING (N) on
å
the TOP (D2). Tighten two TWIST-LOCK® FASTENERS.
Fasten the UPRIGHT (C3) to the TOP (D2). Tighten two
å
TWIST-LOCK® FASTENERS.
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Edge with
TWIST-LOCK®
FASTENER
www.sauder.com/services
N
B2
Finished edge
How to use the SAUDER TWIST-LOCK
1. Insert the dowel end of the FASTENER into the hole of
the adjoining part.
NOTE: The dowel end of the FASTENER must remain fully
inserted in the hole of the adjoining part while locking the
FASTENER.
2. Tighten the FASTENER with a Phillips screwdriver as
tight as possible.
Rounded edge
C3
Surface without
TWIST-LOCK®
FASTENERS
420613
®
FASTENER
Dowel end
D2
Page 11
Publicidad
