PowerSmith PGA2200i Manual Del Operador página 15

WARNING:
Do not smoke or allow flames or sparks in the area where the engine is refueled or where
gasoline is stored. Do not overfill the fuel tank (there should be no fuel above the upper limit mark). After refueling, make
sure the tank cap is closed properly and securely. Using a funnel is recommended. Be careful not to spill fuel when
refueling. Spilled fuel or fuel vapor may ignite, if any fuel is spilled, make sure the area is dry before starting the engine.
KEEP OUT OF REACH OF CHILDREN.
STARTING THE ENGINE (FIG 10)
On a level surface with the engine off, check the engine oil level before each use of the generator.
NOTE:
If location of generator is not level, the unit may not start or may shut down during operation.
To Cold Start the Engine
Before starting the engine, disconnect any loads from the AC and DC sockets.
1.
Turn the fuel tank vent clockwise to the «ON» position.
2.
Turn the engine switch (choke) to the «CHOKE» position.
3.
Pull the recoil starter lightly until you feel resistance then pull briskly. Repeat pulling until engine starts.
4.
Move the engine switch to the «RUN» position immediately as the engine warms up.
5.
Turn the auto idle switch to the «ON» position after the engine has warmed up for 2-3 minutes, engine speed will
decrease or increase according to the electric load, it can help to decrease the fuel consumption. If the auto idle
switch is set in the «OFF» position, the engine will run at high speed all the time.
Do not allow the recoil starter to snap back against the engine, return it gently to prevent damage to the starter or
housing. The output indicator will light green after the engine starting.
1
To Warm Start the Engine
To restart a warm engine, leave the choke in the «RUN» position. Do not move the engine switch to the «CHOKE» position
when the engine is warm or the air temperature is high, it may flood the engine.
AUTO IDLE SYSTEM
With the Auto Idle Switch (22-FIG 1) in the
is disconnected and returns to the proper speed to match the power of the electrical load when the load is reconnected.
This position is recommended to minimize fuel consumption while in operation. In the OFF position, the auto idle system
does not operate. Auto idle system does not operate effectively if the electrical appliance requires rapid cycling power. If
the appliance or tool will be turned ON and OFF quickly, the auto idle switch should be in the OFF position.
When high electrical loads are connected simultaneously, turn the auto idle switch to the OFF position to reduce voltage
fluctuation or shutdown. Appliances with large start-up power demands may not allow the engine to reach normal
operating speed when they are connected to the generator.
English
OPERATION
2
4
ON position, Engine speed is kept at idle automatically when the electrical load
15
3
FIG 10