Transporting/Storage - PowerSmith PGA2200i Manual Del Operador

DRAINING FUEL TANK/CARBURETOR (FIG 18,19)
Unscrew the fuel tank cap, empty the fuel tank into an approved gasoline container using a commercially available
hand siphon. Reinstall the fuel tank cap.
Turn the engine switch to «RUN» position, loose the maintenance cover screws and remove the maintenance cover.
Loosen the carburetor drain screw and drain the gasoline from the carburetor into a suitable container.
Turn the engine switch to the OFF position, and tighten the carburetor drain screw securely.
FIG 18

TRANSPORTING/STORAGE

To prevent fuel spillage when transporting or during temporary storage, the generator should be secured upright in its
normal operating position with the engine switch «OFF». Turn the fuel tank vent fully counterclockwise to the «OFF» position.
WARNING:
Drain fuel completely before transporting in a vehicle. Do not operate the generator while
it is in a vehicle. Take the generator out of the vehicle and use it in a well ventilated place. Avoid a location exposed to
direct sunlight when putting the generator on a vehicle. If the generator is left in an enclosed vehicle for many hours,
high temperature inside the vehicle could cause fuel to vaporize resulting in a possible explosion. Tie down the generator
securely in an upright position while transporting.
English
MAINTENANCE
B
A
D
C
21
A. Spark arrester
B. Spark arrester screw
C. Muffler shield
D. Muffler shield screws
FIG 17
FIG 19