Spout Installation - Brizo Pascal 64900 Serie Manual De Usuario

1

Spout Installation

Place gasket (1) on the sink over the hole
where the spout will be mounted. Feed the
blue electrical connector (2) and hose (3)
through the hole in the sink.
If mounting on a stainless steel sink, mount
stabilization plate (7) between the sink and
washer (4). Mount so the valve body shown
in the following step will use the plate as
well. Discard plate on other kinds of sinks.
Slip the washer (4), with plastic side up,
over the shank of the spout (5). For deck
5
4
2
thickness of 0" to 2 1/2" mount with the hex
side of the nut (6) facing up as shown. For
deck thickness from 2 1/2" to 3 1/2", mount
with the hex side down. Make sure the hole
in the sink is 1 3/8" to 1 3/4" for the thicker
sinks or decks. Snug the nut by hand. Center
the stops for the spout by pivoting the spout
clockwise and then counterclockwise until the
spout stops are centered. Verify the gasket
is completely enclosed by the base and not
visible and then tighten the nut securely using
a crescent wrench or other type of wrench.
3
1
7
6
3