Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION
SPIDER ALERT!
Important: Always ensurethat the venturi burner tubes are clean. A
venturi burner tube has a narrow area in which spiders tend to build
nests.
If you notice that your grill is getting hard to light or that the
flame isn't as strong as it should be, take the time to check and
cleon the burner tubes.
CONTROL
PANEL
SPIDER
WEBS
'_i:.
_
INSiOE VENTURt TUBE
BURNER
Spiders
or small insects have been known to create
"flashback"
problems.
The spiders
spin webs, build nests and lay eggs in the
grilFs venturi
tube(s) obstructing
the
flow of gas to the burner.
The backed-up
gas can ignite in the burner tube
behind
the
control
panel.
This is known as a flashback
and it can damage
your grill and even cause injury.
To prevent flashbacks and ensure good performance the burner
and venturi tube assembly should be removed from the grill
and cleaned before use whenever the grill has been idle for an
_tended
period,
j
Storing Your Grill
" Clean cooking
grates.
" Store in dry location.
" When
LP cylinder
is connected
to grill, store outdoors
in a
well ventilated
space and out of reach of children.
" Cover grill if stored outdoors.
Choose from a variety
of grill
covers offered
by manufacturers.
" Store grill indoors ONLY if LP cylinder
is turned off and
disconnected,
removed
from grill and stored outdoors.
" When removing
grill from storage, follow
"Cleaning
the
Burner Assembly"
instructions
before starting
grill.
Cleaning
the Burner
Assembly
Follow these instructions
to clean and/or
replace
parts of
burner assembly
or if you have trouble
igniting
grill.
1.
Turn gas OFF at control
knobs and LP cylinder.
2.
Remove cooking
grates and heat diffusers.
3.
Remove carryover
tubes and burners.
4.
Detach
electrode
from burner.
.
NOTE: Removal/Detachment
method will depend
on the
burner configuration.
See different
configurations
in
illustrations
below.
Carefully
lift each burner up and away from valve openings.
We suggest three ways to dean the burner tubes. Use the one
easiest for you.
(A) Bend a stiff wire (a light weight
coat hanger works well)
into a small hook. Run the hook through
each burner
tube several times.
(B)
,)
Use a narrow
bottle
brush with a flexible
handle
(do not
use a brass wire brush), run the brush through
each
burner tube several times.
(C) Wear eye protection:
Use an air hose to force air into
the burner tube and out the burner ports. Check each
port to make sure air comes out each hole.
6.
Wire brush entire outer surface
of burner to remove food
residue and dirt.
Z
Clean any blocked
ports with a stiff wire such as an open
paper
clip.
8.
Check burner for damage,
due to normal wear and corrosion
some hales may become
enlarged.
If any large cracks or
holes are found replace
burner.
VERY iMPORTANT:
Burner tubes must reengage
valve
openings.
See illustration at right.
Correct
9.
Attach
electrode
to burner,
burner-to-valve
10. Carefully
replace
burners,
engageme
11. Attach burners to brackets
on firebox.
12. Repositian
carryover
tubes and attach
to burners. Replace heat diffusers
and
cooking
grates.
burner
bracket
Remove
ScreWs
Electrode
Firebox burner
bracket
a fiat blade
screwdriver
464323313
° 13
Publicidad
