Safety Instructions And Warnings; Technical Safety; Intended Use - FALMEC KACL.939 Manual De Instrucciones

SAFETY INSTRUCTIONS
AND WARNINGS
Installation operations are to be carried
out by skilled and qualified installers in ac-
cordance with the instructions in this book-
let and in compliance with the regulations in
force.
Do not modify the electrical, mechanical or func-
tional structure of the equipment.
Do not personally try to carry out repairs or re-
placements. Interventions carried out by incom-
petent and unauthorised persons can cause seri-
ous damage to the unit or physical and personal
harm, not covered by the Manufacturer's war-
ranty.
WARNINGS FOR THE INSTALLER

TECHNICAL SAFETY

Before installing the equipment, check the
integrity and function of each part. Should
anomalies be noted, do not proceed with
installation and contact the Dealer.
Do NOT install the equipment if an aesthetic (or
cosmetic) defect has been detected. Put it back
into its original package and contact the dealer.
No claim can be made for aesthetic (or cosmetic)
defects once it has been installed.
During installation, always use personal protective
equipment (e.g.: Safety shoes) and adopt prudent
and proper conduct.
Keep in mind that installations with different types of
fastening systems from those supplied, or which are
not compliant, can cause mechanical seal danger.
Do not install the equipment outdoors and do not
expose it to atmospheric elements (rain, wind, etc.).
USER WARNINGS
These warnings have been drawn up for
your personal safety and those of others.
You are therefore kindly asked to read the
booklet carefully in its entirety before using the
or cleaning the equipment.
The Manufacturer declines all responsibility for
any damage caused directly, or indirectly, to per-
sons, things and pets as a consequence of failing
to comply with the safety warnings indicated in
this booklet.
It is imperative that this instructions booklet is
kept together with the equipment for any future
consultation.
If the equipment is sold or transferred to another per-
son, make sure that the booklet is also supplied so
that the new user can be made aware of the equip-
ment's operation and relative warnings.
Insist on original spare parts.

INTENDED USE

The equipment is solely intended to be used for
filtering generated from cooking food in non-
professional domestic kitchens: any other use
is improper. Improper use can cause damage to
persons, things, pets and exempts the Manufac-
turer from any liability.
The equipment can be used by children over the age
of 8 and by persons with reduced physical, sensory
and mental abilities, or with no experience or knowl-
edge, as long as they do so under supervision or after
having received relative instructions regarding safe
use of the equipment and understanding of the dan-
gers connected to it.
Children are not to play with the equipment. Clean-
ing and maintenance by the user must not be carried
out by children without supervision.
INSTALLATION
only intended for qualified personnel
Before installing the equipment, carefully read the chapter 'SA-
FETY INSTRUCTIONS AND WARNINGS' .
POSITIONING
The recommended distance between the highest part of the cooker and the
lowest part of the equipment is approximately 110 cm (43.3").
In certain cases, this distance can be increased up to a maximum of approxi-
mately 150 cm (59").
MAINTENANCE
Do not use detergents containing abrasive, acidic or corrosive
substances or abrasive cloths.
CLEANING OF EXTERNAL SURFACES
You are advised to clean the external surfaces at least once every 15 days to
prevent oily substances and grease from sticking to them.
It can be cleaned using a damp cloth, slightly moistened with mild, liquid deter-
gent or denatured alcohol.
Finish off cleaning by rinsing well and drying with soft cloths.
The glass panels can only be cleaned with specific, non-corrosive or non-abra-
sive detergents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with these in-
structions.
CLEANING OF INTERNAL SURFACES
For the internal metal parts, see the previous paragraph.
9