Grill Assembly - Smoke hollow PT300B Manual De Ensamblaje

Piezo
Igniter
Electrode
Wire
Igniter
Housing
6

Grill Assembly

1. Hood Handle Assembly
Hood Handle
Hood Handle
2. Regulator-Valve Housing Assembly
Regulator
Housing
Regulator
Valve
3. Igniter Housing Assembly
A
Bezel Instructions:
Place a handle bezel between each end of
the handle and the grill hood then insert
a 1/4-20 x .50" bolt with washer through
the inside of the hood into each end of the
handle. Tighten the bolts.
Instructions:
Align the holes in the regulator housing
with the threaded holes in the grill firebowl
and insert two 5/32 x .31" bolts with
washers through the holes in the housing
into the threaded holes in the firebox.
Tighten the bolts securely. Screw regulator
valve into threaded hole of the regulator
housing until tight.
Instructions:
A. Thread the electrode wire through the
hole in the igniter housing and attach
the end onto the pin at the bottom end
of the piezo igniter.
-Continue assembly on next page.
1/4-20 x .50" Bolt set (2pcs.)
5/32 x .31" Bolt set (2pcs.)
5/32 x .31" Bolt set (4pcs.)