Smoke hollow PT300B Manual De Ensamblaje página 7

B
4. Heat Tent, Cooking Grate and Warming Rack Assembly
Instructions:
Install heat tent into grill. The
ears on the heat tent should sit
outside of the tabs located in
the grill. Place the cooking grate
onto the grill. Finally, attach the
warming rack by inserting the
two prongs on the backside of
rack through the holes in the lid.
Then insert the front leg prongs
into the holes located along the
side edges of the grill just above
the cooking grate.
FOR YOUR SAFETY, FOLLOW ALL SAFE GUARDS AND INSTRUCTIONS.
Spring Tab
Drip Tray
Drip Tray Access:
The drip tray is accessed for cleaning by rotating the spring
tab and sliding the tray out from under the grill.
NOTE: Shown here without igniter housing for clarity.
Grill Assembly
ASSEMBLY OF YOUR GRILL IS NOW COMPLETE.
Instructions:
B. Align the holes in the igniter housing with
the threaded holes in the firebowl end. Insert
four 5/32 x .31" bolts with washers through
the housing into the threaded holes. When
installing the fourth bolt, first insert it through
the ring at the end of the match holder chain
and then through the housing and into the
firebowl end. Tighten the bolts securely.
Tabletop Use:
Unfold the legs as shown and place grill on a level surface.
When legs are unfolded completely they will snap into the
open position. Dimples in the legs help them remain in
position. To close, simply apply enough pressure to overcome
the friction fit.
7