Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Installing The Handles (See fig 4)
•
Place 2 bushings on handle and slide handle in place with the pre-drilled hole on the generator frame.
•
Insert bolt through the handle and frame and tighten with nut.
•
Repeat on opposite side.
Adding / Checking Engine Oil (See fig 5)
•
Place generator on a level surface.
•
Remove the crankcase dipstick to ensure you do not overfill the engine.
•
Insert a funnel into the crankcase dipstick hold and carefully add 4-Cycle engine oil (SAE10W- 30) to empty reservoir
until oil reaches the outer edge of the oil fill hole (crankcase dipstick hole).
•
Be sure to replace dipstick before attempting to start the engine.
•
To check oil, set generator on a level surface, wipe dipstick clean, then reinsert dipstick without rethreading.
ASSEMBLY
Fig 4
10
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
