Amate Audio X210 Manual De Usuario página 14

X210/X215W/X218W3K/X21T
 -24dB: The amplifier is delivering output power at -24dB of its maximum
power
 -12dB: The amplifier is delivering output power at -12dB of its maximum
power
 Clip: The amplifier is delivering its maximum output power
The connection panel has the following parts:
F) SLAVE OUTPUT FOR X210P
Speakon connector used to feed one slave X210P Line Array Element. In order to
assure proper operation always follow these instructions:
 Link only ONE unit of X210P with each X210A.
 Do not connect a loudspeaker different than X210P to this output.
 Do not change or manipulate this connector.
Misusing the slave output for X210P may lead to serious damage for all involved
equipment, and will not be covered by the Warranty.
G) NETWORK: Computer connection through Ethernet protocol. Two 8-pin RJ45 /
EtherCon® compatible connectors with an internal switch allow the connection of
several units in daisy-chain. Please refer to Amate Audio DSPStudio Quick
Installation Guide for more information on the remote connection.
H) BALANCED INPUT/LINK:
XLR-3 Female balanced signal connector for signal input.
XLR-3 Male connector for parallel connection of various cabinets with the same input
signal.
IMPORTANT: Please always use balanced microphone cable with the following pin
assignment:
1= Shield (Ground) 2= Live (+)
I) AC INPUT/OVERVOLTAGE PROTECTION: These leds show the status of the AC
mains supply.
 POWER ON: (Blue) When lit, the equipment is ON and the AC input level is
within the permitted range (200 to 260 VAC).
 >250V OVERVOLTAGE: (Red) If activated, the AC voltage is out of the
permitted range of the equipment (>260VAC). The equipment will not power
up until this condition is solved. Revise your connections and mains power
installation and consider that other equipment connected to this line may have
been damaged.
J) AC MAINS INPUT/LINK: Mains supply connection via PowerCon.
 Blue connector for AC in.
 Grey connector to feed other units in parallel. Linking up to 4 units of X210A is
possible, provided that a quality cable of a minimum section of 3x2,5mm2 is
14
3= Return (-)
Oct 2017
Amate Audio