Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
"+" and"–" signs above the Clamp Icons, the Arrow Icons and the Alarm Icon will flash. The backlit LCD screen will display the
following:
CAUTION: The unit will suffer permanent damage if the Jump Starter Power Switch is turned on while the clamps
connected with reverse polarity. Disconnect the clamps and reconnect to battery with correct polarity.
• If the Jump Starter Power Switch is turned on and the unit detects that the clamps are not connected to a battery, a two-
second warning will sound every 10 seconds. The LCD screen will display the Battery Status Icon, the Battery Voltage Indicator,
and the Clamp Icons with the "+" and"–" signs. The Alarm Icon and the Jump Starter Icon will flash. The backlit LCD screen
will display the following:
Turn off the Jump Starter Power Switch; connect the clamps to the battery, making sure the clamps are connected with correct
polarity; then turn the Jump Starter Power Switch back on.
• Always disconnect the negative (black) jumper cable first, followed by the positive (red) jumper cable, except for positive
grounded systems.
Procedure
Take the following steps, observing all cautions and warnings in the "Important Safety Instructions" section at the front of this
manual.
1. Turn off vehicle ignition and all accessories (radio, A/C, lights, connected cell phone chargers, etc.). Place vehicle in "park"
and set the emergency brake.
2. Make sure the jump-starter power switch is in the off position.
3. Remove jumper clamps from clamp tabs. Connect the red clamp first, then the black clamp.
4. Procedure for jump-starting a NEGATIVE GROUNDED SYSTEM (negative battery terminal is connected to chassis)
(MOST COMMON)
4a. Connect positive (+) red clamp to vehicle battery' s positive terminal.
4b. Connect negative (–) black clamp to chassis or a solid, non-moving, metal vehicle component or body part. Never clamp
directly to negative battery terminal or moving part. Refer to the automobile owner' s manual.
5. Procedure for jump-starting POSITIVE GROUND SYSTEMS
Note:
In the rare event that the vehicle to be started has a Positive Grounded System (positive battery terminal is connected to chassis), replace steps 4a
and 4b above with steps 5a and 5b, then proceed to step 6.
5a. Connect negative (–) black clamp to vehicle battery' s negative terminal.
5b. Connect positive (+) red clamp to vehicle chassis or a solid, non-moving, metal vehicle component or body part. Never
clamp directly to positive battery terminal or moving part. Refer to the automobile owner' s manual.
6. When the clamps are connected properly, the unit will automatically turn on in jump-starter mode. The backlit LCD screen
will display the following to indicate the unit is ready to jump-start:
The Battery Status icon, Battery Voltage Indicator, Clamp Icons and the "+" and"–" signs light solid. The jump starter icon
will flash to indicate the clamps are properly connected.
10
Publicidad
Tabla de contenido
