Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
condition exists in either of the bottom two USB Ports, the lower set of USB Power/Fault Indicator will flash blue. In either case,
the backlit LCD screen will continuously display the following:
The Fault Icon will flash. The USB Ports will automatically shut down. Should this occur, disconnect the USB-powered device and
press the USB Power Button again to turn off the USB Ports immediately. Make sure the unit does not need to be recharged.
Allow the unit to cool down for several minutes before attempting to use the USB Ports again. If a fault occurs again, make
sure that the total draw of all USB devices plugged into the top two USB Ports does not exceed 3.1A and/or the total draw of
all USB devices plugged into the bottom two USB Ports does not exceed 3.1A. If an individual USB device is within specifications
and the fault occurs, have the USB device checked for malfunction and do not continue to use it with these USB Ports.
Using the USB Ports
1. Press the USB Power Button to turn on all four USB Ports. A beep will sound, the USB Power/Fault Indicators around each of
the four USB Ports will light blue and the backlit LCD screen will continuously display the following:
The Battery Status Icon and Battery Voltage Indicator will light solid, as well as the USB Icon, indicating the USB ports are
ready to use.
2. Plug the USB-powered device into the USB power port(s) and operate normally.
3. Press the USB power button again to turn off the USB Ports.
Periodically check the unit's battery status on the backlit LCD screen. Four solid bars in the battery icon indicates a full battery.
When the battery level is nearly empty with only one solid bar or completely empty with 4 empty bars, the unit must be
recharged at this time or the unit's built-in low voltage protection will activate. The empty Battery Status Icon will flash for a
short period of time before automatic shut down.
IMPORTANT: Make sure the USB Ports are turned off when the unit is being recharged or stored.
Notes:
This unit's USB Ports do not support data communication. They only provide power to external USB-powered devices. The top two USB Ports provide a
total of 3.1A (5V each). The bottom two USB Ports provide a total of 3.1A (5V each).
Some household USB-powered electronics will not operate with this unit.
LED AREA LIGHT
The built-in 3-LED area light is controlled by the Area Light Power Button on the control panel (refer to the "Features" section
to locate). Press the Area Light Power Button once to turn the light on. Press the Area Light Power Button again to turn the
area light off.
IMPORTANT: When the Area Light Power Button is pressed to turn it on, a beep will sound. The backlit LCD screen will turn on
for 10 seconds (only) and will then continuously display the Battery Status Icon and the Battery Voltage Indicator.
Periodically check the unit's battery status on the backlit LCD screen. Four solid bars in the battery icon indicates a full battery.
When the battery level is nearly empty with only one solid bar or completely empty with 4 empty bars, the unit must be
recharged at this time or the unit's built-in low voltage protection will activate. The empty Battery Status Icon will flash for a
short period of time before automatic shut down.
IMPORTANT: Make sure the Area Light is turned off when the unit is being recharged or stored.
CARE AND MAINTENANCE
All batteries lose energy from self-discharge over time and more rapidly at higher temperatures. When the unit is not in use,
we recommend that the battery is charged at least every 30 days.
Never submerge the unit in water. If the unit gets dirty, gently clean the outer surfaces of the unit with a soft cloth moistened
with a mild solution of water and detergent.
There are no user-replaceable parts. Periodically inspect the condition of adapters, connectors and wires. Contact manufacturer
to replace any components that have become worn or broken.
14
Publicidad
Tabla de contenido
