Stanley FATMAX PP1DCS Manual De Instruccion página 12

7. Turn the Jump-Starter Power Switch on. Turn on the ignition and crank the engine in 5-6 second bursts until engine starts.
The backlit LCD screen will display the following:
The Battery Status Icon, the Battery Voltage Indicator, Jump Starter Icon, Clamp Icons and the "+" and"–" signs light solid to
indicate the unit is jump-starting.
8. Turn the Jump-Starter Power Switch off.
9. Disconnect the negative (–) engine or chassis clamp first, then disconnect the positive (+) battery clamp.
IMPORTANT: Always turn the unit off when not in use. Recharge this unit fully after each use.
CAUTION: TO REDUCE THE RISK OF PROPERTY DAMAGE:
• Vehicles that have on-board computerized systems may be damaged if vehicle battery is jump-started. Before jump-starting
this type of vehicle, read the vehicle manual to confirm that external-starting assistance is advised.
• Excessive engine cranking can damage the vehicle's starter motor. If the engine fails to start after the recommended number
of attempts, discontinue jump-start procedure and look for other problems that need to be corrected.
• If vehicle fails to start, turn off the ignition, turn off the Jump-Starter Power Switch, disconnect the jump-start system's leads
and contact a qualified technician to investigate why the engine did not start.
ALTERNATOR CHECK
Set up the unit and connect to the battery following steps 1 through 5 in the "Jump-Starter" section.
PART 1
No Load (turn OFF all vehicle's accessories):
engine long enough to achieve normal idle speed and verify there is a no-load voltage.
1. Press the Alternator Check Button to start the check. The backlit LCD screen will display the following to indicate the unit is
analyzing the alternator:
The Battery Status Icon will light solid and the Alternator Icon will flash.
2. If the unit detects that the alternator is good, the backlit LCD screen will display the following:
The Battery Status Icon, Alternator Icon, and "ALT GOOD" will light solid.
3. If the unit detects that the alternator is out of typical voltage range, the backlit LCD screen will display the following:
The Battery Status Icon, Alternator Icon and "ALT" will light solid. The Fault Icon will flash.
4. Press the Alternator Check Button again to stop the test and turn off the unit.
The vehicle battery must be fully charged before testing the alternator. Run the
11