Brake Assembly Instructions; Controls Operation (Fc20L); Assembly And Disassembly Of Cutter Bar; And Accessories (Fc20L) - NIBBI FC20 Uso Y Mantenimiento

6
12

BRAKE ASSEMBLY INSTRUCTIONS

(FC20 - Fig. 9)
Place the engine on a stable support.
1) Unscrew the wheel fixing screws (1).
2) Unscrew the fixing screws (2) of the axie
shaft support; fix the brake shoe half supports
(4) by using the long screws (13).
N.B.: To avoid oil leaks, it is best to unscrew
the 2 screws, assemble the half-support,
tighten the 2 screws and then repeat the same
operation for the other half-support.
3) Insert the brake shoes (7) on the appropriate
half-support pins.
When assembling, make sure that the brake
shoe springs are in correspondence with the
axle shaft undercuts.
4) Assemble the brake drum (8) and wheel
by means of fixing screws (1).
5) After having removed the handlebar grip,
insert lever (9) and lock it in its position by
using screw (10).
6) Screw adjuster (11) on lever (9).
7) Insert the wire on the brake lever (9) and
on the brake shoe lever control (3).
8) Adjust the lever clearance to 8 mm. by
operating on wire clamp (12) and on adjuster
(11).
9) Reassemble the grip.
1
2
7
Fig. 9
8
9
2
90°
90°

CONTROLS OPERATION (FC20L)

Cutter Bar inclination control lever
The cutter bar is set free when using the lever (2)
and thus allowing the bar itself to travel over 90°
(Fig. 9/A). After having chosen the most suitable
working position, release the lever.

Assembly and disassembly of Cutter Bar

and accessories (Fig. 9/A)
The Mowers are equipped with a Quickfit coupling
which allows a quick and easy connection of
the implements. With engine at stand-still and
machine in horizontal position, pull the latch
(1) and block it in open position by turning 90°.
Remove the machine from the Cutter Bar or other
connected implement. Once the Cutter Bar or an
implement has been connected, turn the latch (1)
until it locks into closing position.
39
4
3 13
10
11
Fig. 9/A
5