Nuna aace Manual De Instrucciones página 12

Securing a Child in Booster
!
Place the booster firmly against the back of a
forward-facing vehicle seat equipped with a lap/
shoulder belt.
!
Have your child sit in the booster with their back
flat against back of the booster seat.
!
Position shoulder belt through the shoulder belt
guide shown in (21)-1 (22)
!
DO NOT position vehicle belt over top of the
armrests. It must pass underneath the armrests.
(21)-2
Route the vehicle safety belt through the belt path
(21), and lock it into the buckle. (21)-3
!
The booster can not be used if the vehicle safety
belt buckle (female buckle end) is too long to
anchor the booster securely. (21)-4
!
The lap belt must be down low on pelvis.
!
To ensure the correct head support height is
obtained, the bottom of the headrest MUST be
even with the top of child's shoulders as shown in
(22).
!
The Vehicle Shoulder Belt must route completely
through the RED Shoulder Belt Guide and not fall
off the child's shoulder. (23)
!
If the belt lays across child neck, head or face,
readjust head support height.
!
Belt must not be twisted.
15
AACE Instructions
Cupholder Assembly
Insert the Cupholder clip into the opening on either
side of seat. (24) Make sure the Cupholder clip is
fully inserted into both the fabric and plastic slot on
booster. (25)
Soft Goods Disassembly
1
- Remove the Cupholder and pull out the seat
bottom fabric by removing the 3 plastic
attachments. (26)
2
- Open 8 snaps on seat bottom and remove soft
goods. (27)
3
- On the main seat back cover, open the 2 snaps
and unhook 4 elastic bands on the back side and
remove. (28)
4
- On the Head Support, raise to highest position,
then unhook 4 elastic bands and remove. (28)
To reassemble the soft goods simply reverse the steps
above.
16
AACE Instructions