REPAIR AND WARRANTY
The instrument circuit contains static sensitive devices,
and care must be taken in handling the printed circuit
board. If the protection of an instrument has been
impaired it should not be used, and be sent for repair by
suitably trained and qualified personnel. The protection is
likely to be impaired if, for example, the instrument shows
visible damage, fails to perform the intended
measurements, has been subjected to prolonged storage
under unfavourable conditions, or has been exposed to
severe transport stresses.
New Instruments are Guaranteed for 3 Years from the
Date of Purchase by the User.
Note: Any unauthorized prior repair or adjustment will
automatically invalidate the Warranty.
Instrument Repair and Spare Parts
For service requirements for Megger Instruments contact
Megger Limited
Archcliffe Road
Dover
Kent CT17 9EN
England
40
Tel: +44 (0)1304 502100
Fax: +44 (0)1304 207342
or
Megger
Valley Forge Corporate Center
2621 Van Buren Avenue
Norristown, PA 19403
U.S.A.
or an approved repair company.
Approved Repair Companies
A number of independent instrument repair
companies have been approved for repair work on most
Megger instruments, using genuine Megger spare parts.
Consult the Appointed Distributor/Agent regarding spare
parts, repair facilities and advice on the best course of
action to take.
Returning an Instrument for Repair
If returning an instrument to the manufacturer for repair, it
should be sent, freight pre-paid, to the appropriate
address. A copy of the Invoice and of the packing note
should be sent simultaneously by airmail to expedite
clearance through Customs. A repair estimate showing
freight return and other charges will be submitted to the
sender, if required, before work on the instrument
commences.
Tel: +1 (610) 676-8500
Fax: +1 (215) 676-8610