Plano De Construcción - ZIEHL-ABEGG ZA top Serie Instrucciones De Uso Originales

Traducción de las instrucciones de uso originales
ZAtop – series de tipo SM200.40D/SM200.45D
Bases de la prueba:
Plano de construcción:
Materiales del eje admisibles:
Materiales admisibles
cubo de la polea de tracción:
Materiales admisibles
muelle de ajuste polea de trac-
ción:
Materiales admisibles
rotor del freno:
A-TBA17_02-E 1910 Index 005
DIN 743-1:2012-12
DIN 743-2:2012-12
DIN 743-3:2012-12
DIN 743-3
Corrigendum 1:2014-
12
DIN 743-4:2012-12
DIN 6892:2012-08
DIN 6892
Corrigendum 1:2014-
05
DIN 5466-1:2000-10
FKM-Guideline 2012
A-20-121-0024 Índice A05 del 21.12.2016
A-20-121-0025 Índice A03 del 23.11.2016
Acero DIN EN 10083-3:2007-01 – 42CrMo4+QT (1.7225+QT)
Acero DIN EN 10083-3:2007-01 – 42CrMoS4+QT (1.7227+QT)
Acero DIN EN 10083-3:2007-01 – 50CrMo4+QT (1.7228+QT)
Acero DIN EN 10083-2:2006-10 – C45+N (1.0503+N)
Hierro colado DIN EN 1561:2012-01 – EN-GJL-300 (GG-30)
Acero DIN EN 10083-3:2007-01 – 42CrMo4+QT (1.7225+QT)
DIN EN 1706:2013-12 AC-AlZn10Si8Mg (AC71100)
Resistencia a la tracción R
Nro. de art. 01010556-E (EU-BD 819/2)
77/80
Calculation of load capacity of shafts and axles –
Part 1: General
Calculation of load capacity of shafts and axles –
Part 2: Theoretical stress concentration factors and
fatigue notch factors
Calculation of load capacity of shafts and axles –
Part 3: Strenght of materials
Calculation of load capacity of shafts and axles –
Part 3: Strenght of materials,
Corrigendum to DIN 743-3:2012-12
Calculation of load capacity of shafts and axles –
Part 4: Fatique limit, endurance limit – Equivalently
damaging continuous stress
Drive type fastenings without taper action –
Parallel keys – Calculation and design
Drive type fastenings without taper action –
Parallel keys – Calculation and design,
Corrigendum to DIN 6892:2012-08
Splined joints, calculation of load capacity –
Part 1: General basis
Analytical strength assessment of mechanical com-
ponents
= 210 N/mm
eN
Anexo
2