Cequent Performance Products 75682 Instrucciones De Instalación

Frame rail
bumper
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75682F
Wrenches: 19mm, 10mm
Deep well socket, Small Flat
Head Screwdriver & Philips
Tip Screwdriver Tip Screwdriver
Plastic
spacer
blocks
10mm
hex nut
Plastic
Philips
rivets
screw
Figure 2
1. Remove fascia door from bumper fascia using a philips tip screwdriver (2 screws). Remove the (4) plastic rivets that
fasten the fascia tabs to the plastic spacer block. Note: Remove the center of the rivet with a screwdriver by first
pulling out center post of rivet. Rivet can then be pushed out by hand. Rivets to be reinstalled. Return plastic fascia
covering and screws to vehicle owner. See Figure 2. i d
2. Remove plastic spacer block that the bumper fascia was attached to with a 10mm socket, to be reinstalled.
3. Carefully, pull the electrical wiring harness located on the inside of the drivers side rail away from rail while installing
the hitch
4. Raise the hitch into position, carefully, lifting the hitch over the fascia (where needed). Secure to impact bumper with
M12 bolts and conical washers into the existing weld nuts, as shown Figure 1. Install remaining fasteners as shown.
5. Tighten all fasteners to the required torque specifications shown below.
6. Reinstall the plastic spacer blocks and (4) plastic fascia rivets removed in step 1 & 2.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2009, 2010 Cequent Performance Products
Impact
Installation Instructions
Fascia
Bumper
fascia
t hi l S Fi
Tighten all M12 CL 8.8 fasteners with torque wrench to 68 Lb.-Ft. (92 N*M)
Cadillac SRX
Do Not Exceed Lower of Towing Vehicle Do Not Exceed Lower of Towing Vehicle
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Frame rail
Fasica door
2
1 1
1
Qty. (6)
2
Qty. (6)
2
Sheet 1 of 3
Part Numbers:
78187
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
5000 (2270 Kg)
4000 (1816 Kg)
Wiring Access Location:
Impact
bumper
Figure 1
Note: Fasteners typical both sides Note: Fasteners typical both sides
Hex Bolt M12X1.75X40 CL8.8
Conical washer 1/2"
75682N 9-2-10
Form: F205 Rev A 5-6-05
75682
87573
44638
U-Haul
Max Tongue
WT (LB)
500 (227 Kg)
400 (182 Kg)
Rev. B