Auxilab 4260/50 Manual De Usuario página 54

Press to set parameters, input the corresponding values of
"Total Time", "Delay Time" and "Time Intervals" according the
screen indicates. Press
Step 3. Set Photometric Mode
Press to set photometric mode, choose "T%" or "Abs." and press
EN TER
to confirm.
Step 4. Set Wavelength
GOTO ʎ
Press to set wavelength, input the value of the wavelength
by numeric keypad and press
Step 5. Measure Samples
Put the sample to be measured in the main light path and put
Reference in the reference light path, press
test, press
WL: 500.0nm
0
Setup
Step 6. Calculate Response Rate
After time scanned, if users want to calculate the response rate
of some period, you can press
Input the
separately and press
would display on the screen.
EN TER
ES C
to cancel.
10:00:00
D2
W
Total T:
180s
Interval:
1.0s
XScale
YScale
Time(s) 180
Mode Process Search
values of "Begin
EN TER
to confirm. Then the value of "I.U."
to confirm.
EN TER
to confirm.
WL: 500.0nm
0 Time(s)
Setup Mode
to go into "Process" interface.
Time", "End
S TART
S TOP to begin the
10:00:00
D2
W
Total T:
180s
Interval:
1.0s
XScale
YScale
180
Process Search
Time" and "Factor"