Tabla de contenido
Publicidad
3.2. Remote control commands
88
3.2.2.66. Info.ActualInfo.Assembly.Counter.V
Info.ActualInfo.Assembly.Counter.Clear
$Q sends the volume. With the function &Info.Assembly.Counter.Clear $G, the
volume counter is set to zero.
3.2.2.67. Info.ActualInfo.Assembly.Meas
Info.ActualInfo.Assembly.PistonPos
$Q sends the current measured value from the assembly.
Piston position:
3.2.2.68. Info.ActualInfo.Titrator.CyclNo
Info.ActualInfo.Titrator.V
Info.ActualInfo.Titrator.Meas
Info.ActualInfo.Titrator.dVdt
Info.ActualInfo.Titrator.dMeasdt
Info.ActualInfo.Titrator.dMeasdV
$Q sends the current values in the following formats:
SET
CyclNo
127
V(ml)
1.2345
Meas:
pH
3.6(mV)
U, Ipol (mV)
-345.6
Upol (uA)
-12.5
T (°C)
-
dVdt (ul/s)
2.5142
dMeasdt
pH,U,Ipol mV/s
0.7957
Upol (uA/s)
0.7957
T (°C/s)
-
dMeasdV (mV/ul) 10.6326
NV: Not Valid. If in the signal drift is OFF in modes MEAS and CAL, the signal
drift is NV.
OV will be sent for "overrange".
A time frame can be set up from the cycle number and the cycle time (see
3.2.2.71). The cycle number is set to 0 at the start of a method and it is in-
cremented until the end of the method.
3.2.2.69. Info.ActualInfo.EP.Index
Info.ActualInfo.EP.X
Info.ActualInfo.EP.Y
.EP.X"1.234" Volume coordinate of the EP
.EP.Y"5.34" Measured value coordinate of the EP
3.2.2.70. Info.ActualInfo.Display.L1
0
=
initial position (filled)
10 000 =
end position (empty)
MEAS
CAL
127
127
-
-
3.345
3.345
-345.6
-
-12.5
-
25.0
-
-
-
0.7957
0.7957
0.7957
-
0.7957
-
-
-
read only
$G
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
read only
up to 24 ASCII characters
719 S Titrino
Publicidad
Tabla de contenido
