NAO EVOLUTION Guía De Seguridad página 6

WORKING AREA
• Start from the Sitting posture (Figure 2), especially when
pressing my Chest Button, or when plugging a cable.
• When turned OFF, it is best to keep me in the Sitting posture,
with no cable plugged unless if charging.
• Ensure a free space is left all around me at start-up.
60 cm (24 inches)
Figure 4: Safe working area
• Do not touch me until I say "Ognack Gnuck"; otherwise, I may
generate unnecessary errors.
• Before starting, make sure I can perform my actions from my
starting location, free from obstacles and danger as in Figure 4.
This requires you to leave me with a radius of at least 60 cm
(24 inches) around me to avoid obstacles.
• In general, leave at least 60 cm (24 inches) all around me
to avoid damage. In particular, ensure I do not run over
any cables around and that cables of the charger cannot
be stepped on or tripped over by a Human, even if the cables
are disconnected.
6
• Make sure the floor surface is hard, dry and level; for example,
do not make me go on thick carpets or rugs, or anything that
can make me fall.
I am designed for indoor use only.
•
• Keep me away from radiators, heat sources and direct
sunlight.
• My operating temperature must be between 15°C and 30°C
(59°F to 86°F).
• My operating humidity range must be between 20% and 80%.
• When not on the floor, NEVER use or allow me to be used
unattended.
STORING
• Use the shipping packaging and foams to protect me
completely.
• If I won't be used for long periods of time, remove my battery
and store me in a dry place, between 0 and 45°C (32 to 113°F),
free from dust, as I don't like dust.
• My battery may discharge during storage.
• For the maximum Battery lifespan, fully charge the Battery
at least once every 3 months even when I am stored.
• To put me into storage: please follow the "Packing NAO"
procedure available online.* Otherwise you may damage me.
• Procedure to remove me from storage:
1/ Remove me from my polystyrene casing.
2/ Charge me.
3/ Turn me ON.
CLEANING
• Before cleaning me:
1/ Unplug all cables from me.
2/ Put me in the Sitting posture (See Figure 2).
3/ Disconnect the Battery Charger from the Socket.
4/ Switch me OFF.
5/ Do not use abrasives, aerosols or other fluids, as they
may contain flammable substances or may damage my
plastic finish. Never spray or submerge me in water or
any other liquid.
6/ Clean me only with products listedin the Documentation.
Alternatively, you may try cleaning me with a soft damp cloth.
7/ Allow me to dry thoroughly before turning me ON again.
* softbankrobotics.com/documentation