Reinstall Grease Filters; Light Bulbs - Best WT32I Serie Instrucciones De Instalación

13. REINSTALL GREASE FILTERS

Rest rear filters edge on filter springs (A) in the hood. Using metal latch tab, tilt
up the filters into position. Make sure filter tabs (B) are securely engaged in
hood front edge after installation.

14. LIGHT BULBS

This range hood must use shielded halogen lamps 120 V, 50 W PAR16 with GU10 base, (2 for the 30" & 36" width hoods, 3 for
the 42" & 48" width hoods), included.
In order to prevent the risk of personal injury, do not install a lamp
identified for use only in enclosed fixtures.
1. Install the lamps by placing the bulb leads into their grooves in the socket.
2. Gently push upwards and turn clockwise until secure.
In order to prevent the risk of personal injury, the halogen lamps must
cool down before removing them.
To remove lamps, gently push upwards and turn counterclockwise to disengage bulb leads from their grooves.
NOTE: To ease removal of the bulbs, use a rubber dishwashing glove or use suction cup tool available from Best. Contact Best
Technical Support at 1-800-558-1711 to order suction cup tool, part no. 99526707.
15. CARE
Before servicing or cleaning the unit, switch power off at service panel and lock service panel to prevent
power from being switched on accidentally. When the service disconnecting means cannot be locked,
securely fasten a prominent warning device, such as a tag, to the service panel.
Grease Filters
Grease filters should be cleaned monthly. Remove grease filters by pulling down on the metal latch tab. This will disengage the
filter from the hood. Tilt the filter downward and remove. Use a warm detergent solution to clean the filters. Let them dry and
reinstall them.
Grease filters are dishwasher safe. Clean all-metal filters in the dishwasher using a non-phosphate detergent. Discoloration of
the filter may occur if using phosphate detergent or as a result of local water conditions — but this will not affect filter
performance. This discoloration is not covered by the warranty.
Interior Blower(s) Cleaning
Remove the filters in order to access the blower(s). Vacuum blower(s) to clean. Do not immerse in water.
Hood Cleaning
Do:
• Regularly wash with clean cloth or rag soaked with warm
water and mild soap or liquid dish detergent.
• Always clean in the direction of original polish lines.
• Always rinse well with clear water (2 or 3 times) after
cleaning. Wipe dry completely.
• You may also use a specialized household stainless steel
cleaner.
Avoid: When choosing a detergent
- Any cleaners that contain bleach will attack stainless steel.
- Any products containing: chloride, fluoride, iodide, bromide will deteriorate surfaces rapidly.
- Any combustible products used for cleaning such as acetone, alcohol, ether, benzol, etc., are highly explosive and should
never be used close to a range.
WARNING
!
WARNING
!
! WARNING
HD0379
Don't:
• Use any steel or stainless steel wool or any other scrapers
to remove stubborn dirt.
• Use any harsh or abrasive cleansers.
• Allow dirt to accumulate.
• Let plaster dust or any other construction residues reach
the hood. During construction/renovation, cover the hood
to make sure no dust sticks to stainless steel surface.
- 10 -
A
B
1
HO0090
2