Assembly Instructions; Battery Operation - Medela Double Select Instructivo De Uso Y Armado

Assembly Instructions

1 1
Follow cleaning instructions on pages 2-4.
2 2
Snap white membranes onto yellow valves
until membrane lies completely flat. (Prior to
cleaning, separate these two pieces.)
3 3
Push assembled valves and membranes
onto breastshields.
4 4
Screw containers onto breastshields.
5 5
Insert white ends of tubing into openings
in breastshields.
6 6
Connect the other end of the tubing to
either side of the motor unit. If single
pumping (one side), be sure the cap is
securely closed on the second side.
6

Battery Operation

The Double Select
1.5V alkaline batteries.
1 1
To install the batteries, press the tab
(PRESS) down to open the cover of
the battery compartment.
Insert the batteries in the correct
position (+ and -) as indicated inside
the battery compartment and snap the
cover back into place.
CAUTION: When using the pump with batteries, the pumping cycle
may slow as the batteries wear down. Slower cycles may cause some
discomfort because the vacuum will be held longer on the breast. If
this happens, reduce the vacuum with the adjustment regulator and
replace the batteries with fresh ones as soon as possible.
NOTE: The batteries do not need to be removed to use electricity to
power the pump.
Electric Operation
1 1
Plug the metal fitting on the end of
the transformer cord into the hole on
the back of the motor unit. (Use only
the Medela transformer #9200013)
Cap
™ Breastpump can be powered by two (2) C
7