Fan Assembly. Pgs - Craftmade Supreme Air 56 Guia De Instalacion

5. Fan Assembly.
Remove blade arm screws and lock washers from
underside of motor in order to remove blue motor
stabilization plate. (Blue motor stabilization plate
may be discarded once removed but save blade arm
screws and lock washers to secure blade arms). [Refer
to diagram 1.]
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower hanging
ball and remove stop pin and then slide hanging
ball off of the downrod. [Refer to diagram 2.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 3.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [Refer to diagram 3.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [Refer to
diagram 3.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes in
yoke--make sure wires do not get twisted. Re-insert
pin and clip that were previously removed. Tighten
yoke set screws and nuts securely. [Refer to
diagram 3.]
Locate canopy cover in hardware pack. Slide yoke
cover, canopy cover and canopy over downrod.
[Refer to diagram 4.] (Note: Canopy cover must be
turned with shiny side toward the motor housing.)
["Fan Assembly" continued on next page.]
diagram 1
set screw
diagram 2
electrical wiring
downrod
clip
diagram 3
downrod
canopy
yoke
cover
diagram 4
page 4
stabilization
plate
stop pin
hanging ball
safety cable
yoke set screw
and nut
pin
motor
housing
canopy cover
motor
housing