Wiring; Canopy Assembly - Craftmade Supreme Air 56 Guia De Instalacion

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6. Wiring.

WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION: Be sure outlet box is properly grounded and that
a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If you
are unfamiliar with electrical wiring or if the house/building
wires are different colors than those referred to below,
please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to the
desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK wire from fan to BLACK wire from
ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from fan
to BARE/GREEN wire from ceiling with wire connector
provided.
Since this fan does not come with a light kit, you will
need to cap off the BLUE wire with a wire connector (as
shown with arrow in diagram). [Note: If you elect to
purchase a light kit for the fan, the BLUE wire from the
fan must be connected to the BLACK wire from the
ceiling instead.]
* Wrap each wire connector separately with electrical
tape as an extra safety measure.

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket and
remove screw closest to the open end of the hanging
bracket. Partially loosen the other screw. Lift canopy to
hanging bracket. Place rounded part of slotted hole in
canopy over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw that was
removed and then tighten both screws securely. Slide
canopy cover up to canopy, aligning rounded part of
slotted holes in canopy cover with screwheads in
bottom of canopy. Turn canopy cover to the right
(clockwise) until it stops.
white supply wire
black supply wire
from ceiling
black
white
white
black
blue
from fan
This fan is remote control adaptable (remote control
sold separately). Note: Only remote controls approved
for DAMP locations can be used with this fan.
screw
canopy
page 6
ground
(green or bare)
wire
connector
ground
(green
or bare)
*
hanging bracket
screw
canopy cover

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sua56

Tabla de contenido