Night Mode; Auto On; DisplayControl; FactoryReset - Monitor Audio Gold W15 Manual Del Usuario

1. Press P1 (or the appropriate preset number) on the
remote. The display will change to prE
2. The display will then change to show the preset number,
eg. 1. Then back to the default display " . "
Selecting a Preset Using the Control
Panel Encoder
With the Gold W15 powered up and out of standby mode, the
system set up using the guides previously, follow the next
steps to recall a preset:
1. Press and hold the encoder down for 3 seconds. The
display will change to PRe
2. Rotate the encoder left or right to show the current
Preset location. eg. 1
3. Rotate the encoder left or right again to change the
Preset number and press to select
4. The display will flash twice to confirm selection, and
then back to the default display " . "

Night Mode

Night Mode enables the user to limit the output of the Gold
W15 without sacrificing any of the performance. This is
beneficial especially when still wanting the sub to be on and
audible at low levels, but don't want the full impact from some
of the more intense parts of a sound track.
NOTE: This feature can only be controlled by the remote.
Controlling the Night Mode Using the Remote
With the Gold W15 powered up and out of standby mode, follow
the next steps to enable/ disable the auto on feature:
1. To turn night mode ON, press the Night Mode button
on the remote (refer to page 6). The display will show
ON and then change to ". ." after 7 seconds. This is the
default display when in night mode
2. To turn night mode OFF, press the Night Mode button on
the remote (refer to page 6). The display will show Off
and then change to " . " after 7 seconds

Auto On

The auto on feature enables the Gold W15 to turn off/ on
automatically, or to be manually controlled. When Auto On
mode is enabled, the user looses the ability to turn the Gold
W15 off into Stand By mode and it will be fully automatic
in operation. With Auto On mode turned OFF, the Gold W15
becomes completely manually operated. It will not turn on or
off when a signal is sensed or removed.
NOTE: This feature can only be controlled by the remote.
Enabling the Auto On Feature Using the
Remote
With the Gold W15 powered up and out of standby mode, follow
the next steps to enable/ disable the auto on feature:
1. Press the "Auto ON" button on the remote. The display
will show the current setting. eg. ON
2. Press the "Auto ON" button again to turn the feature off.
The display will then change to OFF

DisplayControl

If the display is considered too bright for the environment, it
can be either dimmed or turned off completely. The options
available are On, Off and Dim. these are cycled through by
using the remote and are continuously looped.
NOTE: This feature can only be controlled by the remote.
Controlling the Display Brightness
Using the Remote
With the Gold W15 powered up and out of standby mode, follow
the next steps to enable/ disable the auto on feature:
Press the display button (refer to page 6) to cycle through the
options. The display brightness will change as the button is
pressed.
NOTE: If The display is set to off and you wish to change some
features, volume, preset, etc, the display will illuminate and
will stay illuminated for 7 seconds after the final button is
pressed.

FactoryReset

To return the product to it's factory settings and to erase the
memory, a Master Restore can be performed. This is achieved
by:
1. Turning the subwoofer off at the mains power switch.
2. Hold down the encoder, and turn the power back on at
the same time.
3. Keep the encoder pressed for 5 seconds, until the
display flashes RES three times if the factory reset has
been successful.
monitoraudio.com 11