Rear Panel Features - Numark M4 Guia De Inicio Rapido

REAR PANEL FEATURES

2
1
AC IN – Use the included power adapter to connect the mixer to a power outlet. While the power is switched
1.
off, plug the power supply into the mixer first, then plug the power supply into a power outlet.
Note: The mixer is designed to work with the included AC power supply only. Using an incompatible power
supply could result in damage to the unit.
POWER SWITCH – Turns the mixer on and off. Turn on the mixer after all input devices have been connected
2.
and before you turn on amplifiers. Turn off amplifiers before you turn off the mixer.
MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier system.
3.
The level of this output is controlled by the MASTER knob on the top panel.
RECORD OUTPUT (RCA) – Use standard RCA cables to connect this output to a recording device, such as a
4.
CD recorder or tape deck. The level of this output is based upon pre-master levels.
LINE | PHONO INPUTS (RCA) – Connect your audio sources to these inputs. These inputs can accept both
5.
line and phono-level signals. (See #7.)
LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces, to these
6.
inputs.
AUX LINE | PHONO SWITCH – Flip this switch to the appropriate position, depending on the device connected
7.
to the PHONO INPUTS. If you are using phono-level turntables, set this switch to "PHONO" to provide the
additional amplification needed for phono-level signals. If using a line-level device, such as a CD player or
sampler, set this switch to "AUX LINE."
GROUNDING TERMINAL – If using phono-level turntables with a grounding wire, connect the grounding wire
8.
to these terminals. If you experience a low "hum" or "buzz", this could mean that your turntables are not
grounded.
Note: Some turntables have a grounding wire built into the RCA connection and, therefore, nothing needs to be
connected to the grounding terminal.
9. MIC INPUT – Connect a ¼" microphone to this input. Microphone controls are located on the top panel.
7
3 4 6 5
3
8 7
6 6 6 5
9