Front Panel Features; Cd Player Features - Numark CD MIX 2 Manual De Inicio Rápido Del Usuario

powered monitors, or a home stereo. The level of the
master stereo output signal is controlled by the
master fader.
6. Stereo Balanced Master Outputs (XLR): low-
impedance XLR type connectors controlled by the
Master fader.
7. Mic Input: Plug your 1/4" Microphone plug in here.
8. AC In: This mix station is designed to work with the
power supply cord that comes with the unit. While the
1. Input Fader: Controls individual source levels in
the mix.
2. Input toggle switch - Selects which source will be
sent to that channel.
3. 2-Band Stereo Equalizer (EQ) - Adjusts the
treble and bass of each channel.
4. Replaceable Crossfader - Achieves clean fades
between the two input channels. "Hard left" selects
Channel 1. "Hard right" selects Channel 2. With the
crossfader centered, both channels are live. Use the
crossfader for fast and seamless fades from one
selected channel to the other
Note: The crossfader is user replaceable in case of
failure. Simply unscrew the two large screws which
hold it in place, lift it out and disconnect it's cable.
Re-attach the new crossfader and screw the
mounting plate back onto the unit - you're back in
business!
5. Fader Start – Activation allows you to start the CD
players from you crossfader. Travel from left to right
1. OPEN/CLOSE (Disc Tray Open/Close) - Press to
load or eject the disc. Each press will open or close
the disc tray on the transport. NOTE: Tray will not
9.

FRONT PANEL FEATURES

6.
7.
8.
9.
10.
11.
12.
13.
14.
15.

CD PLAYER FEATURES

3
power is switched off, plug the power supply into the
mix station first, then plug it into the outlet.
Power Switch: Use this switch to turn on the mix
station after all input devices are already connected to
prevent damage to your equipment. Turn the station
on before you turn on amplifiers and turn off
amplifiers before you turn off the mix station.
will start the right CD player and pause the left CD
player
Mic Input Fader – Adjusts microphone level.
Mic 1 Equalizer (EQ) – Adjusts microphone 1
treble and bass levels.
Master Stereo EQ – Adjusts the master treble,
middle, and bass levels.
Master Fader – Controls the overall outuput level.
Stereo/Mono Toggle – Changes the master
output between Mono and Stereo.
LED Meter - Indicates the Master output level.
Channel Monitor Selector – Used to route channel
audio to your headphones for cueing.
Cue Mix Control – Adjusts the headphone blend
between master output (PGM) and the channels
selected by the Channel Monitor Selector buttons
(CUE).
Headphone Level – Adjusts cue volume.
Headphone Jacks – Used to connect either 1/8" or
1/4" plugs for audio monitoring with headphones.
open unless the disc has been paused. Tray will
automatically close after 30 seconds.